memo_16f883

#include <stdio.h>
#include <stdlib.h>
#include <builtins.h>
#include <pic.h>
#include <pic16f883.h>
#include <xc.h>

#define _XTAL_FREQ 8000000

// CONFIG1
#pragma config FOSC = EXTRC_CLKOUT// Oscillator Selection bits (RC oscillator: CLKOUT function on RA6/OSC2/CLKOUT pin, RC on RA7/OSC1/CLKIN)
#pragma config WDTE = ON        // Watchdog Timer Enable bit (WDT enabled)
#pragma config PWRTE = OFF      // Power-up Timer Enable bit (PWRT disabled)
#pragma config MCLRE = ON       // RE3/MCLR pin function select bit (RE3/MCLR pin function is MCLR)
#pragma config CP = OFF         // Code Protection bit (Program memory code protection is disabled)
#pragma config CPD = OFF        // Data Code Protection bit (Data memory code protection is disabled)
#pragma config BOREN = ON       // Brown Out Reset Selection bits (BOR enabled)
#pragma config IESO = ON        // Internal External Switchover bit (Internal/External Switchover mode is enabled)
#pragma config FCMEN = ON       // Fail-Safe Clock Monitor Enabled bit (Fail-Safe Clock Monitor is enabled)
#pragma config LVP = OFF        // Low Voltage Programming Enable bit (RB3 pin has digital I/O, HV on MCLR must be used for programming)

// CONFIG2
#pragma config BOR4V = BOR21V   // Brown-out Reset Selection bit (Brown-out Reset set to 2.1V)
#pragma config WRT = OFF        // Flash Program Memory Self Write Enable bits (Write protection off)

・DebugMainProjectでPikKit3を接続しながらデバッグができる。IOVIEWでメモリ状態の確認やその場でbitの変更もできる。